EGG DUO

A1. Can I use the USB A port on the adaptor to charge my phone?

Yes, but only when EGG Duo is not in use as performance may be affected/intermittent playback may occur. The USB port provides a 5V1A output.

BACK TO TOP

A2. How can I distinguish between the Left and Right speakers?

The speakers have an ‘L’ or ‘R’ sticker applied on the rear. If removed, the speaker with the input (source) connections is the Right speaker.

BACK TO TOP

A3. What is the optimal listening position?

Whilst Uni-Q will provide excellent performance at any listening position between the speakers, the optimal placement will be 0.5m-1.5m apart, with the listener the same distance from each speaker (equilateral triangle).

'Toe-in' is also not a requirement – experiment with the speakers positioned ‘flat’ into the room, and slowly angle them inwards to taste.

BACK TO TOP

A4. How do I set the speaker to standby?

You can use the physical button on the RIGHT speaker or the remote control to set the system to standby. The LED is in RED in standby mode.

You can also set the speaker to automatically enter standby after 20 minutes of no signal. Visit www.kef.com/support to download the software tool for EGG Duo to change this setting.

BACK TO TOP

B1. I am experiencing intermittent playback.

Please do not use the power supply USB port and play music at the same time.

If this problem persists, please contact your dealer or local service center.

BACK TO TOP

B2. The LEFT speaker does not have any sound

Make sure the LEFT speaker is firmly connected to the RIGHT speaker with the built-in interspeaker cable.  

BACK TO TOP

B3. I cannot connect to EGG Duo via Bluetooth

If you are unable to connect a Bluetooth device (i.e. mobile phone or tablet), try the following:

• On your device, turn Bluetooth off and then on again
• Delete EGG Duo from the Bluetooth list on your device and connect again
• Turn EGG Duo off and on again
• Press the source button on the speaker for 2 seconds to enter pairing mode
• Move your device closer to EGG Duo and away from any interference or obstructions

BACK TO TOP

B4. I get no audio/audio is intermittent when using optical.

If you are experiencing issues with optical playback, try the following:

• Ensure the cable is connected securely on both ends
• Keep the cable free of sharp bends
• Set the digital audio output settings on the source component to ‘PCM’ – not Bitstream, Dolby or similar (refer to the components manual for instructions)

BACK TO TOP

B5. I have connected a subwoofer, but there is no output.

Some subwoofers have an ‘auto-on’ or ‘Music Sense’ feature, meaning they turn on when they receive a signal. At reduced volumes, the signal may be too low to trigger the subwoofer.

BACK TO TOP